![]() The collapsing cord will save your back – literally! Like the harness line, the collapsing cord should also be made out of UV resistant marine grade polypropylene rope. The collapsing cord is often overlooked as an integral piece to your drift sock kit. (5) Collapsing Cord – Should be a 15- 20 foot Marine-Grade/ UV resistant 1/2-inch cord. (4) The Collapsing Strap – This is strap where your collapsing cord will tie on to. (3)The Point – The narrow end of the drift sock. I recommend a drift sock that is made from heavy duty, construction grade rip-stop nylon material. (2) The Bucket – Is the opening where the water will get pushed to. The harness strap needs to be made of a durable nylon material strapping. (1) The Harness Strap – These straps attach to the Bucket and to the harness line. Let’s start from wide-end to the narrow-end: The drift sock has several parts that give its unique characteristics. You might be inclined to, but this could have terrible consequences.ĭragging the sock through the water using ordinary rope increases the chances the sock will twist, tangle, hinder the drift sock performance, and wind up frequently removing the harness from the sock and untangle the lines. WARNING: Do NOT use an ordinary rope to attach your drift sock to your boat. Here’s the solution… simply detach the drift sock from your boat! land that monster fish and then come back for the floating drift sock. Finally, it also aids you in landing monster fish! Those who are hooked into a giant fish tend to get worried their line will get tangled in the drift sock ropes.In the event your harness and collapsing line comes off your boat, the buoy keeps the entire drift anchor afloat.Allows the entire system visible at all times.It keeps the drift sock towards the top of the water surface, which increases performance and helps to avoid any unwanted snagging on submerged structure.The harness line with buoy serves four functions: The buoys will range in size from 4-8-inches in length. You will notice the better harness lines should have a highly visible buoy. ![]() This will make it so much easier when you attach and remove both the harness from your boat. The premium harness lines come with stainless steel quick release clips on both ends. ![]() Harness lines should be at least an ½-inch thich and should range between 10- and 16-feet in length to give you optimal control. Marine grade cordage rope is known to resist drying out, fraying, and frankly it can last you nearly a lifetime. The harness line should be a long 100% UV resistant marine grade polypropylene rope. In order to use your drift sock system you should have these three important pieces: They go on to say one of the drift socks best features is to slow their boat drift into a rocky shore just in case they can’t get their motor started.ĭrift Sock Anatomy 101 | What Makes A Good Drift Sock Kit? I’ve sat down with other owners of drift socks. This could be instrumental to allow rescuers to find that boat quickly and easily. Other recreational boaters also like to have 1-2 drift socks handy, just in case their motor goes out on them the drift sock will help slow their drift. Anyone who fishes out of a boat, canoe, kayak, stand up paddle board, or any other type of floating vessel should have a drift sock ready to use. In addition, the drift sock can also be used to hold the boat position when it is anchored.įishermen are the most common people who use a drift sock for trolling. A drift sock can be attached to either of the sides of the boat (port), the front of the boat (stern), or the rear of the boat (aft). The most common way drift sock is used is to slow down a boat’s drift. The kit usually comes with 1-2 marine-grade ropes, a buoy and the actual drift sock itself.Ī drift sock can be used in a variety of ways. The better drift socks usually come in a kit. It can also be easily folded up and stored when not in use. More often than not a drift sock will be made up of a nylon cloth material, but the cheaper versions can be made of a cheap tarp-like material. Simply speaking, a drift sock (also known as a drift anchor) is like a parachute, or a large funnel-like product but for the water.
0 Comments
Leave a Reply. |